At the 2018 Energy Science & Technology Conference, Dr. Gerald Pollack who is a professor at the University of Washington presented on the 4th Phase of Water. This is considered to be some of the most authoritative and advanced science in the world of subtle energy research dealing with water.
Dr. Kurt Kung attended the University of Washington and worked closesly with Dr. Pollack who was his advisor at the time and currently, they are partners in ongoing water research and technologies. So if you are looking for more authoritative information on methods to measure subtle energy changes in water, this is the presentation for you.
Dr. Kung starts with an overview of some of his work with EZ water, which is the 4th Phase of Water known as “Exclusion Zone” water, which you would be familiar with if you studied Dr. Pollack’s work. This is what Dr. Kung is referring to when he is discussing the properties of Interfacial Water and its net negative charge.
The charge separation that happens when this EZ water is produced is very important because there are two very different types of water that are in close proximity to each other and they do not mix. Therefore, there is a high and low potential or dipole that is formed directly in the water.
What that means is that you can literally create a battery using one source of water that is simply in contact with a hydrophilic surface, which in turn creates the EZ water separation – if you have two potential differences in that water, then you have a battery. That in fact is what Dr. Kung did – by stringing a bunch of those water cells in series, he was able to light an LED to prove the point. It is a ways off before this is something that can produce large amounts of power, but it is in its infancy and is a profound discovery.
RS Stafford is a long time researcher in the energy sciences and knows more about John Bedini’s work than most. He is blessed to have been able to acquire John Bedini’s 6 coiler SG and the large Ferris Wheel Motor.
Here is the goal and why we need your help to raise some donations:
Investigate John Bedini’s Ferris Wheel Hub Motor and Mag amp Motor to get a better handle on how this Tech works. Map out the Magnetic Fields around the various magnets and coils. Document and study all the various values of the components. Add extra Energy producing equipment to demonstrate various concepts that John Bedini has shown us.. And to show case experiments beyond what JB was allowed to show us. Then Bring the Ferris Wheel to the 2020 Energy Science & Technology Conference for a full Presentation.
The below is an excerpt from the full length vendors & announcement videos from the 2019 ESTC.
We need to start here with one very important and valuable piece of information… Paul Babcock is now dedicated to open-sourcing his life’s work in the electrical sciences. He wants to empower the masses with some very profound information that took millions of dollars to learn.
This presentation does indeed contain some weird things relating to overunity effects, but Paul actually shows you the specific waveforms his circuits created when demonstrating overnity. This has never been disclosed to the public before.
A lot of information relating to overunity principles have made it out to the public but in Paul’s opinion, it hasn’t really taken root yet in any substantial way. Many overunity effects are also like ghosts where they come and go so how can we pin it down?
There is definitely some kind of aether weather that influences the machines with its own rhythms where the overunity ebbs and flows – how do we reconcile all of this with conventional physics, which teaches us that these things can’t happen?
Our own perception limits our ability to comprehend these higher dimensional processes and on top of that, most of us are unable to solve problems in certain ways once we are used to solving problems in other ways.
It is important to understand that there are many commonalities throughout many machines that are overunity or in other words, they output more work than is required for us to input into them. Paul will spell these out in no uncertain terms – at least for the type of machines many of us have direct or second-hand experience with.
AIR GAPS – the air has important magnetic properties, which is the secret to many overunity machines and Paul will walk you through many details specifically related to this. Ed Gray, John Bedini and others used these principles that apply to the air and its interesting qualities. This specific information is worth its weight in gold even if this is the only thing you get from this presentation.
Paul will also cover some aspects to Dr. Harold Aspden’s work. This work overturns Einstein’s Relativity as commonly understood as does the work of other forward-thinking scientists. What is so important about Dr. Aspden’s work is that it is using nothing more than relatively simple algebra that describes, time, space and other concepts in simple ways that makes them make sense in a very practical way.
Space itself has “energetic” properties and this is a huge part of the picture that everyone should understand so their foundation has meaning when it comes to the “free energy” sciences.
Something else that is important besides air gaps and energetic properties of space is phase switching – going from electric to magnetic and back to electric. Again, it is necessary to restate the importance that these are commonalities that exist across many overunity machines.
Tesla was known for the ideas of separating the so-called electrons from the radiant energy component of electricity and Paul covers this as well. This presentation is simple enough that most people can understand the concepts even without a background in electrical engineering.
The aforementioned switching methods elicits anomolous TIME effects in batteries, hence the subtitle to this presentatin – IT’S ABOUT TIME – it has more than one meaning. Twenty years ago, John Bedini told me that the capacitors were receiving a TIME charge, but many people didn’t not understand how literal that was. Paul will be going into these concepts from his perspective, which carries a lot of weight. He’s done it with his own builds and he has seen others do it too.
Paul covers his experience with John Bedini’s “Glass Case Motor” and how batteries that were so dead they were corroding away – yet they ran the motor, produced mechanical work, lit LEDs and charged themselves up!
Ed Gray’s motor technology exploited some of these effects and again, Paul wil show you the waveforms that showed the overunity in his own circuits. his inverters showed 106% and his other circuits showed higher such as in his lighting circuits.
And, you will learn how there can be overunity when measuring less than 100%. Much of this comes from Jim Murray’s teachings of how to correctly account for everything happening in a system and when you understand this, you may realize that you too may have overunity but were never able to realize it. This information is very important because most people do not properly account for all the input, output and losses. It’s all about distinctions and this will be spelled out for you.
If you’re serious about overunity and achieving it, this is a must-have presentation that is sure to open your eyes.
In the last few years, Prof. Haralick became interested in subtle energy research but many of the experimental results were not explainable by the common paradigm. Some of his work in this area was presented at the last couple Energy Science & Technology Conferences.
It became apparent to him that there should be a theory that can begin to explain some of this unusual phenomena.
His interest was primarily focus on whether or not Maxwell’s Equations could be generalized so that it could be used to explain some of this work specifically including the type of work Tesla was involved with in the early 1900’s regarding longitudinal waves.
Prof. Haralick will walk you through a very specific sequence of segments that include:
James Clerk Maxwell – an interesting biographic sketch that quite likely, many mathematicians and engineers have not heard of.
The Maxwell Equations in Modern Form – a general review to set the stage for a comparison of the rest of the presentation.
Maxwell’s Original 20 Equations – this takes you back to the original 1865 paper that he had before he wrote his treatise. Prof. Haralick has a strong intent to figure out what was in those equations in the way that Maxwell wrote them because what many people have said is that what Maxwell had in his equations are not the same as what the Heaviside-Biggs Equations are that are currently used.
Quaternions – this goes into the quaternion algebra, which sounds complicated but if you have any background in the most basic high school algebrea, you’ll understand quite a bit of it.
Quaternion Generalized Maxwell Equations – you’ll then be walked through the derivation and this derivation admits to a longitudinal electric wave along with the scalar wave and this type of “scalar wave” will most likely shock you. So far this comprises a little less than half of the presentation.
Tesla, Galinas, Zimmerman, & Hively – the rest of the talk regarding the work of these men, what they built and what they wrote that is relevant to this kind of generalizaton as well as other related topics. Some of the material covered in this section may reveal to you some thing that you have not previously realized – especially regarding Tesla’s work.
Get a copy of this presentation so you can have an authoritative analysis of Maxwell’s Equations that reveals a very specific type of “scalar wave”, which not been openly discussed in any literature on the subject.
Jack Hanlon, Ph.D. believes over unity electrical machines have been built and even demonstrated many times at the ETSC and other places; however, he has never heard a complete explanation of “how they work” that will stand up to the skepticism of a conventionally trained mathematician, physicist or engineer.
The explanations always seem to involve some “mysterious” source of power or slightly nebulous use of magnetism.
The missing piece is always: what is the source of the extra power?
Since we have been unable to answer this question in a satisfactory way, the technology is put in the realm of “voodoo” science, and it is not seriously considered by the larger traditional scientific community.
He believes this holds back the wide spread and rapid development of this important technology and limits the developers to a small community of experimenters.
Switched reluctance generators have always been a prime candidate for overunity results. Eric Dollard who is very skeptical about any “free energy” claims was originally brought into Borderlands years ago to verify a switched reluctance generator built by Peter Lindemann and Michael Knox. Accounting for a sufficient margin of error, Eric Dollard found that it did indeed produce more work than it took to run the machine!
This is probably the most comprehensive analysis on where the free energy is in such machines and it is done in a relatively simple and eloquent manner with simple algebra and geometry.
This presentation covers the difference between Tesla’s balanced method and Lakhovsky’s unbalanced method. Other aspects of the MWO pulse modulator are also presented that are normally considered proprietary information.
Here is the free viewing of the first Panel Discussion with Paul Babcock, Aaron Murakami, James DeMeo PhD, Robert Haralick PhD, Jack Hanlon PhD, & Eric Dollard.
There is a wide range of topics in this discussion with an emphasis on a living ether. Both Dr. DeMeo and Eric Dollard give some interesting insights into the Orgone energy and wait until you hear what Eric’s personal experience was with a small orgone accumulator. It needs to be replicated far and wide!
Please share this far and wide!
Leading Publishers of Advanced Energy Science, Founded in 2008 by Aaron Murakami & Peter Lindemann