My 1934 HotRod page

57chevy.gif (18309 bytes)hotrod_blvd.gif (15329 bytes)hotrod_road_md_wht1.gif (17702 bytes)

My friend Aaron and I started this project December 15 2001.

I found this old 1934 truck cab buried in a outside garage covered with junk . Aaron and I built the frame all by hand as you will see by the pictures.

scrap1.jpg (41894 bytes)

We moved the cab and box ( not much of a box) to My shop garage and wondered how to do this.

scrapp2.jpg (48729 bytes)

This will give you the indication what shape this shell was in.

scrappe3.jpg (49927 bytes)

This is what the inside looked like"NOTHING" not even a dash.

jackstand1.jpg (51288 bytes)

Building the frame rails to match the body.

weldfr1.jpg (53379 bytes)

Welding the frame together

attlefs1.jpg (53682 bytes)

Attaching leaf spring mounts to the end of frame rails

weldfrot1.jpg (51288 bytes)

Welding on the front support, aligning radius rods.

radious1.jpg (48938 bytes)

Final welds of radius rods aligning front end to frame

shock1.jpg (54739 bytes)

Welding the shock towers into place.

bottom1.jpg (53711 bytes)

Welding in the floorboard with battery box compartment.

firewal1.jpg (45549 bytes)

Welding in the firewall.

rearend1.jpg (53947 bytes)

Welding the pads on the rear end, aliening leaf springs.

trackbar1.jpg (54905 bytes)

Adding the traction bars and shock mounts

steer1.jpg (49669 bytes)

Welding in the Vega steering box then adding grade 8 bolts for safety.

pibrk1.jpg (46928 bytes)

Welding in breaking system attaching break lines, master cylinder is Mustang II.

frontgrill1.jpg (56853 bytes)

Aligning the front grill, welding motor mounts checking for clearance.

motortrns1.jpg (41844 bytes)

Aligning the motor and transmission and drive shaft for the correct angles.

steeringwheel1.jpg (53772 bytes)

Mounting the S10 steering wheel.

boxxx1.jpg (52235 bytes)

Now it's time to stretch the 1931 box that did not go with this truck.

cutbox1.jpg (51927 bytes)

I took the die grinder and cut the pickup box to fit the frame.

resbox1.jpg (48143 bytes)

Welding the sheet metal in to re-make the pickup box.

 

 

Next Page